Nails
MenuMENU
SearchSEARCH

Technique

Should I remove the gel overlay from my client's damaged nail?

April 17, 2010

When bleeding occurs under the nail plate because of an injury, it is referred to as a “traumatic hematoma.” As blood pools in the hematoma, it eventually creates enough pressure that the rate of blood flow is reduced to the point where normal clotting occurs, then further bleeding stops.

As long as the normal skin barriers around the nail are not violated, it would be very difficult if not impossible for an infection to occur. If the nail plate fractures or if the distal edge of the nail has separated away from the nail bed, then caution would be appropriate—cleansing with hydrogen peroxide and applying topical antibiotic ointment should be sufficient to prevent infection. It should not be necessary to remove the overlay.

If the client experiences pain due to the buildup of the hematoma, an old trick is to have her take a paper clip, unfold it, heat one end over a gas flame (be careful not to burn the fingers holding the paper clip) and carefully touch it on the nail plate over the hematoma. It should be possible to melt a small hole in the nail plate which then relieves the pressure. If this is done, hen care must be taken as outlined above to avoid infection. Eventually the hematoma will grow out and the nail should return to a normal appearance. One last word of caution: Occasionally, malignant melanomas can appear under fingernails and may look just like a hematoma. A “hematoma” that gradually enlarges may not be a hematoma at all and should be evaluated by a dermatologist. -- Dr. MacGougall


Let me start by answering the last part of your question first. Yes you should be worried about an infection starting under this nail. Whenever there is bleeding, no matter what part of the body, an opening through the outer protective barrier of the body has been created. It sounds as though the protective seal between the hyponichium and the nail plate was broken. This opening in medical terms is called a “portal of entry” and through it organisms, such as bacteria and fungi, can gain entry into the underlying tissues. Given the right condition an infection will ensue. So as a general rule, whenever one sees bleeding she must always think about the possibility of an infection occurring in the area.

If the nail is partially lifted off the nail bed as the result of the injury, I do not think that the gel overlay should be removed. The procedure of removing it would only add trauma to the already injured nail and nail bed. Instead, trim the nail back as short as possible to reduce the risk of further injury from catching it on things and causing further lifting from the nail bed. The client must keep the area clean and apply an antibiotic ointment under the free edge of the nail as protection against infection. At the first sign of an infection (extra pain, swelling, redness, heat, or drainage) the client should seek medical help. -- Dr. Mix













Topics:gels

More FAQ

Problems with edges when doing acrylics?

I am still having a problem with my edges when doing acrylics. I would like to just get it right so I am not touching the sides and the cuticle.... read more

What is the best way to clean gel brushes?

I just started using gels. What is the best way to clean gel brushes?... read more

LED lamp efficacy across gel brands

Will the new LED lamps work with regular UV gels such as IBD, CND, or Star Nail, or does it only cure hybrid gels such as Gelish, Shellac, Gellac and other soak-off gels?... read more

How do I convince clients to try GelColor by OPI?

How do I convince clients to try GelColor by OPI?... read more

Can humidity cause lifting?

I live in central Florida. Every year when the humidity rises, natural nails start separating from the enhancements on the sides of the free edge. This leads to the enhancements chipping away. Every year, all summer long, I’m rebuilding free edges using forms and product. I’ve tried using a dehumidifier, but it does not seem to be helping.... read more

How can I get acrylic nails to shine better using top coats?

Can you tell me why when I use a top coat on acrylic nails the shine does not come out well? I must admit I don’t do the three-way shine after using the final white block prior to a polish application, but is there a best top coat for pure, long-lasting shine?... read more

Removing Gels to Apply Acrylic

There are many gel nail salons around where I live, meaning there are many people with gel nails. I do acrylic nails and I’m wondering if there is a special removal method to follow for gels because I know they don’t soak off like acrylic. I have a lot of people coming to me with their gel nails still on. Do I just thin them down as good as I can and apply the acrylic as usual? Will the acrylic still adhere with that thin layer of gel on? Or do I need to completely get rid of the gel and get to the natural nail to be able to apply the acrylic?... read more

Cleaning Dried Acrylic Off Brush

I need advice on how to get dried acrylic off my nail brush. I did my first set of fills today but now I am wondering how to clean my brush. My friend said soak it in acetone and then wash it really well. Could this affect my brush or is it OK to clean it?... read more

Acrylics Suddenly Lifting and Have Air Bubbles.

I’ve been a nail tech for three years and have worked at a few salons. I have since opened my own salon and am now having a problem with my acrylics. I am having a lot of lifting and air bubbles in the middle of the nail. I have never had this problem before. My technique has not changed. My prep is good. I remove the cuticle, rough up the nail, and prime. I have tried a few lines of products and it’s happening with all of them. Could it be the environment of the new shop? Please help!... read more

Clogged Airbrush

I have an airbrush machine that I have used one time. After that I have not been able to get any paint to spray out. I even bought a new attachment just in case I did something wrong or did not clean it properly. But before I try it again and risk ruining another attachment, can you please tell me what I might have done wrong? Is there a way to fix this problem?... read more

How can I make a correct C-curve without a tip and achieve an oval shape?

I don’t use tips — I’ve never been a fan. I build my pink-and-whites from scratch and have always been much happier with how they look and wear — my clients are too. But how can I make a correct C-curve without a tip and achieve an oval shape? I have several clients with an oval shape but I can’t get them this pointy and they end up having straighter sidewalls.... read more

I need help selecting a good UV light. What should I look for? Is price a good indicator?

I need help selecting a good UV light. What should I look for? Is price a good indicator?... read more