Nails
MenuMENU
SearchSEARCH

Technique

Should I remove the gel overlay from my client's damaged nail?

April 17, 2010

When bleeding occurs under the nail plate because of an injury, it is referred to as a “traumatic hematoma.” As blood pools in the hematoma, it eventually creates enough pressure that the rate of blood flow is reduced to the point where normal clotting occurs, then further bleeding stops.

As long as the normal skin barriers around the nail are not violated, it would be very difficult if not impossible for an infection to occur. If the nail plate fractures or if the distal edge of the nail has separated away from the nail bed, then caution would be appropriate—cleansing with hydrogen peroxide and applying topical antibiotic ointment should be sufficient to prevent infection. It should not be necessary to remove the overlay.

If the client experiences pain due to the buildup of the hematoma, an old trick is to have her take a paper clip, unfold it, heat one end over a gas flame (be careful not to burn the fingers holding the paper clip) and carefully touch it on the nail plate over the hematoma. It should be possible to melt a small hole in the nail plate which then relieves the pressure. If this is done, hen care must be taken as outlined above to avoid infection. Eventually the hematoma will grow out and the nail should return to a normal appearance. One last word of caution: Occasionally, malignant melanomas can appear under fingernails and may look just like a hematoma. A “hematoma” that gradually enlarges may not be a hematoma at all and should be evaluated by a dermatologist. -- Dr. MacGougall


Let me start by answering the last part of your question first. Yes you should be worried about an infection starting under this nail. Whenever there is bleeding, no matter what part of the body, an opening through the outer protective barrier of the body has been created. It sounds as though the protective seal between the hyponichium and the nail plate was broken. This opening in medical terms is called a “portal of entry” and through it organisms, such as bacteria and fungi, can gain entry into the underlying tissues. Given the right condition an infection will ensue. So as a general rule, whenever one sees bleeding she must always think about the possibility of an infection occurring in the area.

If the nail is partially lifted off the nail bed as the result of the injury, I do not think that the gel overlay should be removed. The procedure of removing it would only add trauma to the already injured nail and nail bed. Instead, trim the nail back as short as possible to reduce the risk of further injury from catching it on things and causing further lifting from the nail bed. The client must keep the area clean and apply an antibiotic ointment under the free edge of the nail as protection against infection. At the first sign of an infection (extra pain, swelling, redness, heat, or drainage) the client should seek medical help. -- Dr. Mix













Topics:gels

More FAQ

Why is it that most of my acrylic clients are having lifting by the cuticle area?

Why is it that most of my acrylic clients are having lifting by the cuticle area? I prep properly, removing all the oils from the nail beds, and I prime twice. I’ve even considered using an 80-grit file. What can I do or what am I doing wrong?... read more

My clear and acrylic nails appear dull or frosted. What am I doing wrong?

After I apply clear or natural acrylic nails, they don’t appear clear. They have an almost frosted or dull look. What am I doing wrong? Am I applying too much?... read more

How to I keep wraps from lifting on a client with poor circulation?

I have a client with very poor circulation, and therefore, very cold hands, making it difficult to keep her silk overlays from lifting. I have already tried pH balancers and extra silk and resin, but the lifting continues to occur. What else could I try that might work?... read more

If I don't etch the nails before applying acrylics, do I need to apply more primer?

During my training for fills, I was taught to etch the natural nail regrowth for the strongest hold and to prevent lifting. Yet, I recently read that a technician did not etch the nail because it causes so much damage. I agree, but wonder what the major difference would be without etching? Should I apply more primer?... read more

Is it common to have to change products or procedures depending on the weather?

Is it common to have to change products or procedures (including changing the ration of the products) depending on the weather? Is it possible for perspiration to make the product lift?... read more

Can you over-cure gel?

Can you over-cure gel?... read more

Why do some of my clients feel a burning sensation when I use my e-file?

I have only had my license for six months, and I have definitely found that my e-file cuts down on time. The only problem is when I’m reducing the acrylic to take off old product, some of my clients feel a burning sensation. I make sure I’m not applying too much pressure. I have my RPM set at 15,000 and usually use a medium-grit sanding band. What can I do about this? Should I go back to carbide bits?... read more

Why do some people wear gels over acrylic extensions?

I’ve heard that some people wear gels over acrylic extensions. Why do they do this, and how do you do this? Is there anything you have to be careful of during the application?... read more

I’ve heard that some people wear gels over acrylic extensions? Why do they do this, and how do you do this?

I’ve heard that some people wear gels over acrylic extensions? Why do they do this, and how do you do this? Is there anything you have to be careful of during the application?... read more

When I’m reducing the acrylic to take off old product, some of my clients feel a burning sensation. What can I do about this?

I have only had my license for six months, and I have definitely found that my e-file cuts down on time. The only problem is when I’m reducing the acrylic to take off old product, some of my clients feel a burning sensation. I make sure I’m not applying too much pressure. I have my RPM set at 15,000 and usually use a medium-grit sanding band. What can I do about this? Should I go back to carbide bits?... read more

Myth Busters: Will suntan lotion mixed with the ocean's salty water turn gels to goo?

I heard that if you go into the ocean with a lot of suntan lotion on, the small amount of acetone in the suntan lotion interacts with the salt water and can run down your fingers and turn your gels to goo. Is this true?... read more

What’s the trick to getting dark glitters to cure when doing rock star gel nails?

What’s the trick to getting dark glitters to cure when doing rock star gel nails? I do my nail prep, then a layer of Akzentz Base N Gloss. I cure and put another layer of Base N Gloss, then sprinkle on the glitter and tap off some of the excess. I cure after that, and I brush off the excess again when it’s done, but a lot of glitter will come off with it. And this is with a brand new gel lamp. So I put on more gel, more glitter, etc., but I’d like to get it right the first time to save time.... read more